OK you've signed up for and you're ready to build something cool and Internet-connected. All you need is this starter kit which will get you going with lots of parts that go very well with our service and are the most common sensors and actuators you may want. Sense light, motion, humidity, temperature, and more, then send it for storage on ! Light up LEDs, make noise, and move a motor when a trigger is detected.
This pack is designed for people who want to use the new low-cost Adafruit Feather HUZZAH with ESP8266 WiFi microcontroller and are comfortable with that platform to explore IoT. A Feather HUZZAH development board is included. An Arduino or other microcontroller is not required.
This pack DOES NOT include a standard USB micro-B cable (use any cable you have as long as its sync charge not 'charge only'), a solderless breadboard, or a (take your project on the go!) - you will need a USB cable to program and debug your HUZZAH & either USB or a Lipoly battery to power the Feather HUZZAH. You may also want . Some soldering is required to assemble the Feather HUZZAH ESP8266 and HDC1008 sensor.
This pack includes:
- Micro servo
- Huzzah Starter Pack Component Bag
- 1x Breadboard-friendly SPDT Slide Switch
- 1x Diffused RGB (tri-color) LED
- 1x Piezo Buzzer
- 1x Photo cell light sensor
- 3x 12mm Tactile Switches
- 1x Diffused 10mm Red LED
- 1x Diffused 10mm Green LED
- 1x 10K Trim Potentiometer
- 5x 10K 5% 1/4W resistors
- 5x 560 ohm 5% 1/4W resistors
